The commands available on a Block are as follows:

Commands on a Block

SysML diagram: Launch the SyML diagram creation wizard.

Distributed property: Creates a DistributedProperty.

Reference: Creates an Attribute.

Connector property: Creates a ConnectorProperty.

Participant property: Creates a ParticipantProperty.

Part: Creates a Part.

Flow port: Creates a FlowPort.

Port: Creates a Port.

image024.png (298 Bytes) Etienne Brosse, 29 September 2011 10:30

image025.png (318 Bytes) Etienne Brosse, 29 September 2011 10:30

image018.png (36.8 KB) Etienne Brosse, 29 September 2011 10:30

image019.png (515 Bytes) Etienne Brosse, 29 September 2011 10:30

image020.png (564 Bytes) Etienne Brosse, 29 September 2011 10:30

image021.png (415 Bytes) Etienne Brosse, 29 September 2011 10:30

image022.png (504 Bytes) Etienne Brosse, 29 September 2011 10:30

image023.png (553 Bytes) Etienne Brosse, 29 September 2011 10:30

image026.png (36.7 KB) Etienne Brosse, 29 September 2011 10:30

image009.png (1.45 KB) Etienne Brosse, 29 September 2011 10:32